Bolt M8 BFS 8 For steel substructures
Stud M8 for steel BFB 8
STUD-ST-BFS8-LT15-LS14-M8
Register now and access more than 125,000 products
Practical tip:
- To prevent the connection between the bolt and the mounting substrate being overloaded by torsion forces, the corresponding female thread must be screwed tightly using a torque wrench
- Recommended tightening torques: M6/M8
- Concrete surfaces: 4 Nm/6 Nm
- Steel surfaces: 6 Nm/8 Nm
All bolts are suitable for secondary attachments (without technical approval). The maximum tensile forces of individual attachments are at the discretion of the user and must be determined with test attachments or pull-out tests.
Datasheets(X)
 | |
Material | Steel |
Surface | Zinc plated |
Shaft length (Ls) | 14 mm |
Shank diameter (ds) | 4.0 mm |
Thread length (metric thread) (Lg) | 10 mm |
Thread type x nominal diameter | M8 |
Suitable for device type | Würth BST 350, Hilti DX 2, Hilti DX A40, Hilti DX A41, Würth BST MA-75 (single shot kit for single fixtures), Hilti DX 350, DX 36M, DX 460, DX 5 |
Last viewed
Sandpaper strip Useit® Superpad wood
Hexagon Socket Head Cap Screw ISO 4762/DIN 912, steel 8.8, zinc-plated, blue passivated (A2K)
Speed grinding disc For steel
Metric double open-end wrench DIN 3110/ISO 1085
Metric double box-end wrench with POWERDRIV®
Hexagonal bolt with thread up to the head ISO 4017, steel 8.8, zinc-plated, blue passivated (A2K)
Hexagonal bolt with thread up to the head ISO 4017, steel 8.8, zinc-plated, blue passivated (A2K)
System insert 8.4.1, circlip pliers
Hammer drill H 22-SLE
Sandpaper roll Useit® Superpad wood