Bolt M8 BFB 8 BFB 8 DIN EN 206
Stud M8 for concrete BFB 8
STUD-CONC-BFB8-LT15-LS27-M8
Register now and access more than 125,000 products
Practical tip:
- To prevent the connection between the bolt and the mounting substrate being overloaded by torsion forces, the corresponding female thread must be screwed tightly using a torque wrench
- Recommended tightening torques:M6/M8
- Concrete surfaces: 4 Nm/6 Nm
- Steel surfaces: 6 Nm/8 Nm
All bolts are suitable for secondary attachments (without technical approval). The maximum tensile strength of individual attachments are at the discretion of the user and must be determined with test attachments or pull-out tests.
Datasheets(X)
 | |
Material | Steel |
Surface | Zinc plated |
Shaft length (Ls) | 29 mm |
Shank diameter (Øds) | 4.0 mm |
Thread length (metric thread) (Lg) | 10 mm |
Thread type x nominal diameter | M8 |
Suitable for device type | Würth BST 350, Hilti DX 2, Hilti DX A40, Hilti DX A41, Würth BST MA-75 (single shot kit for single fixtures), Hilti DX 350, DX 36M, DX 460, DX 5 |
Last viewed
Reusable cable tie with plastic latch
Foam strip for painting PERFECT MASK
Sharpening stone For diamond cutting discs, cup wheels and core drill bits (excl. PCD)
1/4-inch socket wrench insert, TX head For external TX screws
Collated nails and gas cartridge NG CS-2/3
Max bushing chisel
1/2 inch adapter With 1/2 inch square socket and 10 mm hexagon socket
pias® drilling screw with hexagon head and drill tip Case-hardened steel, zinc-plated, blue passivated
Extension tube For PURLOGIC® COMBIpress and PURLOGIC® XPRESS foam guns
Front fixing hook For Nova Pro Scala H186/250 and Crystal Plus