Bodywork pull clamp Box
Bodywork pull clamp, box type
PULCLMP-BDYWRK-TYP-BOX-2PULDIRECT
Register now and access more than 125,000 products
- Large overhang of the jaws, allowing e.g. angled sheet metal too to be securely encompassed.
- The two pulling eyes allow straightening jobs in two pull directions at the same time.
- The jaws are fixed to the component with non-slip properties using the clamping screw. The retention force of the jaws is automatically increased through the linear pulling action (clamping cone).
- The pulling eyes can be connected with a slide hammer or a chain using hooks.
Datasheets(X)
Product weight (per item) | 2269.000 g |
Last viewed
Blind rivet attachment For processing aluminium, steel and stainless steel blind rivets 2.4-5.0 mm in diameter
Connector DIN 7427 1/2 inch
Tipmatic magnetic pin For inset mount
AL 10 long plate pair
Jigsaw blade, construction, three stars multiblade
Plug-in screw terminal strip For flexible, rigid and single-wire copper conductors
Hexagon Socket Head Cap Screw ISO 4762/DIN 912, steel 8.8, zinc-plated, blue passivated (A2K)
Raised countersunk head screw with H recessed head DIN 966, A2 stainless steel, plain
Hexagonal bolt with threading up to head DIN 558, steel 4.6, plain
Hexagonal bolt with threading up to head