Aluminium angle brackets Sheet metal roof
Mounting bracket for sheet-metal roofing
MNTBRKT-SOLCOLL-ALU-LL9MM-PL138X30X5
ZEBRA
Register now and access more than 125,000 products
Height compensation
Angle brackets can compensate unevenness of up to 20 mm using the slot
Fully pre-assembled
Mounting rails 39 x 37, 47 x 37 and 60 x 37 can be attached to the angle brackets without preparatory work
Bonded EPDM sealing strip on the bottom of the angle bracket
Optimum protection against moisture
- It should be ensured in advance that the sheet metal is sufficiently attached to the substructure. The maximum load-bearing capacity of the sheet metal should also be checked. Approval must be obtained from the manufacturer, particularly in the case of sandwich roofing elements. We recommend using two thin sheet metal screws with 4.5 x 25 sealing washer (art. no. 020154525) to attach each bracket.
- Not suitable for flat roof elevation mounting
 | |
Base hole diameter | 5 mm |
Matière | Aluminium |
Longueur | 138 mm |
Height | 64 mm |
Épaisseur | 5 mm |
Width | 30 mm |
Datasheets(X)
Last viewed
Injection system case for components of the WIT injection systems
Sealing tape VKP® TRIO
Multi-line laser MLPG 22
3/4-inch impact socket wrench insert hexagon, metric, short
Joint smoother geometric shape with angled edges
Distance bushing set 3 pieces
Test box combi 12 V
Pneumatic impact screwdriver DSS 3/4 inch H
Twist drill bit HSS DIN 338 type RN 130°
Hexagon Socket Head Cap Screw ISO 4762/DIN 912, steel 8.8, plain
