Adhesive tape, waterproof elastic tape
Adhesive tape waterproof ELASTICBAND
SEALTPE-ELASTICBAND-0890353020-80MMX10M
Register now and access more than 125,000 products
- Self-adhesive
- With viscoelastic layer of butyl rubber
- Coated with a non-woven polypropylene fabric that allows deformation in the transverse direction while limiting longitudinal deformation
- Supplementary product for water-resistant coatings and mortars to ensure water tightness in conflict areas of the substrate, such as joints or where any two substrates meet
- Suitable for indoor and outdoor use
Storage: Store in sealed original packaging in a cool, dry place. Protect from light, frost and excessive heat.
The usage instructions are recommendations based on the tests we have conducted and on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting with deliberate intent. We guarantee the consistent quality of our products. We reserve the right to make technical changes and further develop products.
Datasheets(X)
Surfaces such as terraces, balconies, roofs, swimming pools, shower trays. Bridging of expansion joints before applying seal.
The surfaces must always be resistant, firm, dust-, paint-, wax- and oil-free and perfectly cured. Peel off the self-adhesive paper on one side only and apply it to the substrate with firm pressure. Separate the paper gradually, it is recommended to make strips 2 metres long. Proceed in the same way with the other side of the tape. Make sure that the strip does not trap air bubbles. The substrate can then be sealed.
Width | 80 mm |
Length | 10 m |