2C repair filler RSM For all wood and imitation wood surfaces
2C repair filler, RSM
RETCHPUTY-2C-WO-REPAIRFILLER-RSM-WHITE
Register now and access more than 125,000 products
Excellent load-bearing capacity
Similar hardness and rigidity to wood. Highly weather-resistant.
Quick to use
Dries within just a few minutes, does not drip into holes and recesses, and can withstand stress within 20-40 minutes depending on the room temperature.
Suitable for painting over
The filler can be painted over using a large number of coating systems.
High adhesion to wood materials
Very easy to sand
Silicon-free
Ensure that the compound does not become too hard. 2C repair filler RSM.
The usage instructions are recommendations based on the tests we have conducted and are based on our experience; carry out your own tests before each application. Due to the large number of applications and storage and processing conditions, we do not assume any liability for a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no responsibility is assumed by this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee consistent quality of our products. We reserve the right to make technical changes and further develop products.
For closing, filling and repairing scratches, cracks, open joints, holes, pressure areas, crushed and broken edges, as well as for securing broken bolts, hinges, bushings and fittings.
In small portions, the filler must be firmly pushed into the repair area in order to achieve optimum anchoring. Remove excess compound using glass film and plastic plane. After curing, level the surface with sanding paper. The colour of touch-up areas can be adjusted using the retouching paint box. A clear varnish can be used to alter the level of the gloss, which seals the damaged area. For more information and preparation guidance, please refer to the technical data sheet.
Chemical basis | Polyester resin |
Colour | White |
Density | 1.94 g/cm³ |
Smell/fragrance | Styrene |
Density conditions | at 20°C |
Max. open time | 5 min |
Conditions for open time | after addition of hardener |
Min. curing time | 20 min |
Max. curing time | 30 min |
Max. temperature resistance | 110 °C |
Min. flashing point | 34 °C |
Ignition temperature | 490 °C |
Contents | 180 ml |
Included in delivery | 10 g hardener + accessories |
Shelf life from production/conditions | 24 Month / at 10°C |
Last viewed
Spare spring for secateurs
Machinist's hammer German design in accordance with DIN 1041
Multi-purpose drill bit MFD-S Plus
TX double box-end wrench
Circlip pliers, shape C For bore circlips
Plastic multi-purpose Zebra Shark® anchor without collar
Metric combination wrench with POWERDRIV®
Hexagon drive For Fixograss 9000 drilling jig, SBL-3 and VBL-2
Pin punch set, large dimensions 5 pieces
Hex head screw with thread up to head ISO 4017, A2-70 stainless steel, plain