1-component combination foam PU for roof tiles
1C combination foam PU for roof tiles
COMBIFM-1C-ROOFTILE-B3-750ML
Register now and access more than 125,000 products
Specifically for fitting roof tiles and interlocking roof tiles
- Guarantees outstanding adhesion even under the most extreme conditions
- Suitable for most construction materials (such as concrete, roof tiles, interlocking roof tiles, wood etc.)
- The grey colour matches conventional mortar perfectly
Particularly high mechanical resistance
- Especially strong PU adhesive with high adhesive force
- Higher tensile strength than conventional systems (18 N/cm²)
- Exceptional resistance to weather (e.g. wind etc.)
- Resistant to insects, parasites, mould and fungus infestation
Revolutionary installation system
- Significant time, effort and cost savings
- Quick and practical to use on the job
- Safe and user-friendly
The adhesive doubles in size after application
After application, all parts of the adhesive gun covered with PU adhesive must be cleaned with the special cleaner before the adhesive hardens on the gun
If the cartridge was not emptied completely, it must not remain attached to the gun for longer than a week
Remove non-hardened adhesive splashes and smears with the cleaner
Hardened adhesive can be removed with the special cleaner
The product does not adhere to polyethylene, PTFE, silicon or surfaces treated with release agents
Does not contain formaldehyde
Moisten surfaces with water before applying the adhesive. Moisten individual adhesive layers with water during and after application.
Although the technical notes reflect our experiences and should be adhered to, the information is provided only by way of example. This should be confirmed by thorough practical tests before any application.
It remains the purchaser’s responsibility to personally test our products to see whether they are suitable for the intended use
Datasheets(X)
Suitable for fitting roof tiles. Can be used on plaster, cement, wood, stone, metal etc.
Chemical basis | Single component polyurethane |
Colour | Light grey |
Smell/fragrance | Pungent |
Moulded density | 0.01 g/cm³ |
Cell structure | Fine |
Tack-free after | 10 min |
Conditions for being tack-free | at 20°C and 60% humidity |
Can be cut after | 45 min |
Conditions for ability to cut | at 20°C and 60% relative humidity |
Full resilience | 24 h |
Conditions for full resilience | at 20°C and 50% relative humidity |
Min./max. surface processing temperature | -10 to 35 °C |
Min. surface processing temperature | -10 °C |
Max. surface processing temperature | 35 °C |
Min. temperature resistance | -40 °C |
Max. temperature resistance | 90 °C |
Building material class | B3 - Of high flammability |
Building material class conditions | in accordance with DIN 4102-1 |
Contents | 750 ml |
Weight of content | 733 g |
Shelf life from production | 24 Month |
Conditions to maintain shelf life from production | at 20°C |
Last viewed
1/2 inch socket wrench insert metric, hexagon, short
Pull handle ST/A200
Hexagon head serrated screw with flange W-0273, steel 100, plain
VARIFIX® Standardfix hammer head fastener Pre-assembled with nut and washer, A4 stainless steel
1/4" socket wrench insert metric, long
LED tubes, T8 with G13 socket, 330 degrees
Anchor rod WIT-C 200, yellow zinc-plated steel
Window frame screw AMO®-Y 11.5 mm
Collated nails and gas cartridge NG CS-2/3 HFB
Brass cable gland, metric